Beautiful flower in quilling technique

Beautiful flower in quilling technique

Beautiful flower in quilling technique

flower, we are going to do is:

1

a lot of work to be – after all elements in the flower more than 30, but it is very entertaining process 🙂 proceed.
with petals. take 2 strips for the quilling 3 mm different colors, I have this bright pink and red (suit and personally cut strips of double-sided paper. glue these strips. the length of the resulting glued strips I have about 65 cm and looks so strip

2

we will petals 22, 22 are preparing glued strips

3

of each strip, we will turn off rolls – the main element of quilling. twist the rolls and to dissolve them to a diameter of 2 cm. should start with color, which is in the middle lobe (I have it – red).

4

5

then roll ….. do the work piece in the form of “eye.” for this we are squeezed our roll on both sides. work piece will need to how to flatten to the “eye” turned sharp

   SONY DSC

strictly speaking, this can be stopped and, a couple of crap that’s such a simple color

7

but we will not look for easy ways 
Take each work piece and using the awl (toothpicks, thick needle … someone like that) is slightly twirled one of its edge.

8 9

We get ready petal! or rather, a bunch of ready-made petals

10

Thus, our harvesting took place this evolution: Sklene strip roll, “eye”, ready to tab

11

proceed to the middle, the flower? guess what we will do first? praaavilno, glue 2 strips of different colors! I – yellow and green.

12

get a long strip of 105 cm. I wanted to middle, it was a major. of course, we turn it roll. but not to dissolve it, and leave a dense, just the tip of the strip 

    SONY DSC

cut the paper strip 1 cm wide and long enough to wrap around the midway. the top edge is pasted strip of contrasting color. something like this:

14

and happily cut into noodles

15

wrap the strip around the midway noodle (I glued both to contrasting stripes looked inside), an expanding middle, … ready!

    SONY DSC

then again, it would be possible to stop … but it’s not in our nature :-))) and we continue! We do leaves. It’s all very simple. take strips of different shades of green: 5 lighter, darker 5. bands of lighter we turn rolls and dissolve them to a diameter of 2 cm from the darker bands – up to 3 cm., and proceed with etmimi rolls as well as with the petals: do one eye and tighten the tip.

17

all “parts” are ready to flower. You can shout “Hurrah!” and start collecting blanks in a flower. You can make the flower flat, this blank simply glued to the base (postcard, a picture, etc.). and you can make a flower volume. often used for this purpose such cones

    SONY DSC

make it easier than ever: cut a circle (about 3 cm in diameter), cut a small sector (really small, the cone was not very deep. and the flower will stick), glue. and this cone paste it onto our. Important: twisted ends of the petals have to look in one direction. first, the first layer

19

then the second (curved petals located in the opposite direction to the first layer of petals) and midway. I stuck everything in hot melt, it saves time.

20

the reverse side of the cone is pasted onto

21

and to hide the error gluing, cut another circle, cut the edge in the noodles and glue on top of the leaves.

       SONY DSC

23

In general, as stated in a good cartoon from my childhood: “Tra-la-la, tra-la-la … alley-op! Voila !!!”

24

I get a beauty that can be used anywhere! I hope useful

25 26

Courtesy: niakriss.blogspot.in