How to make flower shape jewellery box

flower shape jewellery box

How to make flower shape jewelry box

 flower shape jewellery box

For work, we need two kinds of PVA glue, paint and breadboard knives, scissors, compasses, brush, drawing paper, wallpaper, cardboard (I took a box of pizza), black artistic ground, masking tape and acrylic enamel “metallic gold.” And most importantly, the 6 tubes of toilet paper rolls or reels 6 of the tape.

 flower shape jewellery box

Vertical, in which cuts roll, identified by a thread. secure with sartorial pins at the other end tied to load, set the roll on the table to load hanging freely made series. They held the line and cut.

 flower shape jewellery box

Cut rolls moistened with an atomizer and dried to form.

 flower shape jewellery box

Well, now it is because of what was conceived and the MC. How to calculate the pattern bottom? It is necessary to measure the distance between the ends of the “hemisphere” compass. I R = 10 cm. If the rolls are less than or the other form, the distance would be different /

 flower shape jewellery box

Draw a hexagon using the measured radius R of a circle (radius equal to the side of a hexagon circumscribed circle, it is known from school course geometry). For hexagon arc (the pattern must be removed from inside the arc circling dried parts). It turns out a flower. Its size depends on the steepness of the arc of dried-up rolls.

 flower shape jewellery box

Cut with a paint knife.

 flower shape jewellery box

We connect individual parts masking tape.

 flower shape jewellery box

Attach the bottom.

 flower shape jewellery box

So it looks from above.

 flower shape jewellery box

PVA cloth pastes diluted with water.

 flower shape jewellery box

Draw Picture flagella of wipes in the art Pape art. Glue peas.

 flower shape jewellery box

Cut the cardboard cover, circled the bottom and making allowance 0.8 – 10 mm, whichever you prefer. Important: be sure to number the petals on the bottom and the lid, combining them. because they may differ in form from each other (rolls still not exactly the same)

 flower shape jewellery box

Cover pasted over with napkins, a drawing “stencil”. We make application of the flagella.

 flower shape jewellery box

Paint all black acrylic primer.

 flower shape jewellery box

The soil is still wet.

 flower shape jewellery box

Here, I missed one step: the manufacture and wrapping wallpaper inside of the lid: It is made of 0.3 cm smaller than the bottom around.Lepestki I also indexed, then another, and customized by inserting it into the bottom part of the finished boxes. using a mock knife cutting off the excess. Then plastered wallpaper. At this stage, it is important to pay attention to the direction of the corrugations of the outer and inner parts are perpendicular. Otherwise, the inside of the cover.Na glued tape, which will act as a hinge.

 flower shape jewellery box

Align the numbers of petals, glued both sides of the lid, locking pegs for 10-15 minutes

 flower shape jewellery box

Then remove the pegs and put under the yoke of the night.

 flower shape jewellery box

Morning, plastered the interior of the box Whatman pre-pasted wallpaper. (Alas, this stage also forgot to take a picture), then almost dry sponge walked acrylic enamel “metallic gold.”

 flower shape jewellery box

And this is the result.

 flower shape jewellery box

Cover with another light.

 flower shape jewellery box

Please do not judge strictly, this is my first master class. I ventured it only in order to show how you can.Ved does it is not difficult for any size bobbins.

courtesy: stranamasterov