Myrtle flower from nylon
Firstly, Preparation: you must first prepare tkakie materials: dark green, light green, white or purple, red nylon, 22 #, 24 #, 26 # wire; 2 # flower stalk, dark green, light green, yellow, white, red ribbon, red, yellow stamens PEARL.
Second, as shown below:
1) take the # 26 wire wound around the needle,
2) to make a circle, leaving a long-handled,
3) two layers of white nylon
4, 5) white tape wrapped around the roots of the petals, red ribbon wrapped around the stem
Third, the longer it takes for the nitty gritty:
1) yellow tape about 10 cm cut in half
2) take 1/8 (10 cm) wire size # 26, half red stamens
3) cable and Zhemchuzheny stamen folded and tightly wrapped with yellow ribbon
4) for each flower to make seven long stamens
Four assembly Flower:
1) take the 1/3 (about 27 cm) # 22 wires, hold about 30 small yellow stamens
2 Cut the bottom of the stamens, tightly wrap the thread
3) add seven long stamens
4) in turn primotat six petals
5) plus six leaflets (# ring, light green nylon)
6), and finally wind light green ribbon
One flower complete (as indicated above)
Five, bud:
(You can also use foam beads for the manufacture of kidney)
1) take the # 26 wires of about 10 cm, hold the end of the wire (or the foam ball)
2) a white layer kaprolna
3) the red thread around the ball 3 laps
4) one or two layer light green Capron (external or internal bud)
5) wrapped around a light green ribbon
Sixth, do the leaves:
1) take the # 24 wires DO # 3, # 4, # 5, # 6 Circle (leave the leg)
2) convert it into a form sheet
3) green nylon
4) to wrap green tape
Seven Mounting:
1) build bud
2) the assembly of colors
Courtesy:Â www.liveinternet.ru