Creating birds from velvety plastic

I invite you to a craft on creating birds from velvety plastic. Birds get easy, suitable for both home decoration flowers and flower

To begin prepare tools and materials:

1. Aluminum wire, 1 mm.
2. Wire beading.
3. The weight for modeling “Kaklyaka-Grafik» or «I Clay» company «Amos».
4. Foil.
5. Round, scissors.
6. Is there any thing for rolling mass (I have a glass of tequila).

I molded just three birdies until sculpt one, the other two dry up. Let’s go! Cut wire d – 1 mm and a length greater than the planned tail twice.

Winding wire for the tail with foil, leaving a half outside.

Making the frame feet of beading wire.

Corrects the body and tail, insert foot.

The tail gently pull out, so that you can paste back. Birdy mnёm not, but it is not fit! Roll out the sausage and flatten it. Inside put the future tail, riding on a flat surface. The table is also nice :)

Insert the tail into the hole where it belongs

Doing so Circuits, unroll it.

Then you can stick round to close the foil. Wriggle your fingers:

We receive such preparation:

First, center, then fasten it to the fingers:

These tabs out:

Making the cheeks of these “droplets” and the top, add the beak from a piece of mass conical shape:

Such blanks receive. You can still drew level their weight.

Aligns birds on how much patience enough to sculpt two ball eye and put them into place, and then add the upper and lower eyelids, fingers and gently wriggle stack:

Turned birds with naked eyes:

Now you can add all sorts of beautiful, to create the effect of feathers. To cut the long feathers beading wire and rolled into the mass for modeling. After drying, the ends of rounds to finish Round or feathers at the ends.

Feathers can be done, just roll out stronger like droplets and lined it a needle. Then attach those curlicues. You can make such a roll out on the table and wrapped tip.

Effect of feathers obtained if the wet mass to impose a piece (not wet!) On a needle body and work toward growth of feathers. This may be done either prior to attachment of the wings, or after.