How to embellish a vase with ribbon

Hi all, maybe even you happen to need to renew something that we have at home and now we get tired of seeing, I happen often, and so here I am to change clothes to an old vessel that now I could not bear. Here below as I turned.

Before it was so.

I thought I’d cover it with cotton webbing that I glued all ‘around the pot, I spent hearty glue and then I started to go around the approaching vessel well the tape wire.

Up to terminate the entire surface of the vessel. I put glue in a bowl, I elongated with a little water and I brushed abundantly throughout the tape.

I then left to dry very well.
I then put the acrylic color (burnt sienna) in a small bowl and I mixed with a little glue and a little water, I mixed well and I passed on the entire tape with a brush being careful to cover all spaces.

I thought I would dress it with a more and braid tape, which I did by making a very simple chain, you can do with a big hook or just with your hands.

It makes and gradually slips in and pulling and so on until you have the length you need.

hat’s above the finished chain.
I stuck to the neck of the vase, I cross, I did go down and I joined the two leaders at the back, I’m sorry but I miss the photo of this step, I still think you understand it anyway. After that, I did well to dry the glue and I went back the color (burnt sienna), insisting well in all areas of the webbing. Allow drying for a few hours.

With a dry brush, I passed the yellow mustard dipping slightly and always downloading the excess color on a piece of paper. Brushstrokes I recommend reading. Air dry and here he is ready to be used again.

courtesy: centomilaidee