From plastic bottles bright flowers
The Job:
From two paperboard blanks cut flowers of different sizes.
Templates blanks cut from plastic. In the center of the flower warmed awl to make holes. singe the edges of the petals candles.
Suitable for weaving flower copper wire. The length of the wire depends on the length of the bud. Dress on the wire a little piece.
Now dress big piece.
Twist the wire around the flower.
At one end of the wire dress one hole through the first workpiece large, then small.
Thread the wire through the second hole.
Putting 2 flower.
Twist the wire around the second flower.
Putting the next flower.
Twist the wire around the colors and intertwined.
So plёtem entire bud. At the end of the wire should remain tails about 5-7 cm.
From the green bottle cut strip. Length and width of the sheet depends on your desires. Tips a little sharpen and singeing over a candle.
In the middle of the sheet to make the holes and folded in half.
Use thicker wire.
Gently pushes the wire through the bud. We correct colors, close to the wire.
Tail copper wire wrapped around a thick.
Winding stem.
And now, hyacinth flower rain we turned out!