Necessary tools- platypus for the convenience of content for small parts, side cutters to cut the excess length of the pin most important tool. If the first 2 tools necessary for convenience, without the third, did not get to collect a bracelet. With them, we do loops.
And of course, we need to hat pins (25 mm), with a loop (30mm), Toggle-clasp (you can use any other fastener that you have). If you have long pins, then cut off their side cutters.
For this bracelet, I used 6 round beads made of natural malachite 10 mm, and 36 beads 8 mm (natural malachite, Czech glass, chrysoprase, pearl brown, and natural malachite) and one metal flat beads to fit the length of the bracelet on the arm and the cap for beads color antique gold
To start to collect our 36 small beads 8mm. Strung on a pin with a hat first, then bead. Fold the pin using the platypus as close to the bead and Round-do loop.
On pin with a loop strung hat, then a large bead 10mm, then a hat and do a loop, as in the last photo. But do not close it until the end.
With the help of pliers make of pin or wire rings that are worn on the watch on both sides. In the ring, Unfortunately, the very first link I forgot to take a picture. But I think this photo is clear. If not, write, I shall photograph on another bracelet. we will collect our ready-made beads
Unfortunately, the very first link I forgot to take a picture. But I think this photo is clear. If not, write, I shall photograph on another bracelet.
Dress ring on the previous unit, stick to it and continue platypus it all the beads in the order as indicated on the photo 3 small beads with a loop on one side, a large bead with loops on both sides, 2 small beads with a loop on one side
Here’s a design we have. We continue as long as you are not satisfied with the length of the bracelet. I have a 16 cm wrist circumference, turned 3.5 links on each side
Here is the bracelet, if hung vertically
You can see that too (fastener) is attached to a bracelet, too, a ring. If the ring is not used, the fastener is tight and not convenient to fasten the bracelet with one hand
Earrings are collected on the same principle as the bracelet. On small beads loop with one hand, large- both sides. The only difference is that on both sides of the small beads are caps, hats in a bracelet from one side only
I hope I have inspired you to collect these wonderful bracelets. If there are questions- ask, happy to share their experiences
