I suggest you join me to make just such a frame of the test. This is a great gift for lovers and newlyweds
Frames can be put on a shelf and even hang on the wall
Go
To start knead the dough, as usual: 2 cups flour, 1 cup salt, and almost a whole extra glass of water.
Roll out a layer of 5-7 mm thickness. We apply the template to the photo. Remember, it must be smaller than the photo on the 0.5 cm on each side.
Precisely cut off excess dough.
Now cut out the middle, and it also gently pull out.
Somewhere it should look like the foundation for the frame
Now ordinary ruler forced veins. This can be and do. But look at what is already a pretty frame))). if you sculpt relatively recently, add a couple of flowers and leaves in the corners will not be difficult, and there will be a beautiful result
I do not expect when the substrate is dry, first for a long time, and secondly on the raw surface is easier to fasten Circuits). Covers gouache my desired color.
Here is a semi-finished product can be said
Now do the ribbon for printing …
We put a zigzag
Brush I Burst streaks
Fantasize on
Lepim leaves. Take the dough is already tinted in green (I tinted dye for eggs). Patty press down the back of the leaf. Who has special Molde – general beauty
Such is the leaf neat
Doing it on the edges of the knife recess
We put at his discretion in the framework of different places
Here’s what happened
Now the turn of flowers. In this case, will be daisies. Take patty knife and outline the petals.
Now we sit down rod flower poking directly into the center.
Toothpick making streaks.
You can daisy do more in another way …
Now syringe stack letters from the colored dough. Lepley hearts and ladybugs
She was drying 5-7 days, I do not remember exactly … to paint watercolors. The result was a bright enough))). Then he opened the varnish for yachts, and that’s what happened.
Now it’s up to the substrate. Need a double cardboard, paperboard front (I with a pattern, but it is not required), a thin ribbon strips cut from the ceiling slab.
On the frame is cut support for the legs also cut trapeze. Make the through holes in the legs and the base substrate at the bottom of the center.
Now we turn over our support and leg with an awl make holes through
The holes are threaded wire several times, leaving a loop so you can hang on the wall.
on the reverse side twirl wire and hide in a hole.
Now threaded ribbon
PVA glue lubricates the substrate layer
Top glue nice cardboard
Now laid the strip ceiling tile glue “Dragon”, and also the top we put the same glue.
Carefully putting a picture frame, and the substrate was equal stripes. We look forward to when dry, about two hours.
Now fasten the tape on the leg. Pretends as our frame will stand and not fall
Now glue the ribbon planting.
To be beautiful, white cardboard to seal
Well, and it is ready
And pretty, and not expensive))) Yes, and your hands
