How to make “Fairy House” night light

I began thinking up a size, shape and electro-filling.
Moulds steel boxes of plastic for freezing. One more second less. Put them into each other so that the edge is on the same level, it consolidated the skewers and the doorway between us filled layers serpyanku. Making sure that all derzhet, flooded gypsum. The thickness of the walls turned out higher than planned. At another time I will take a box with a tight plastic.
The gypsum should be well cool. The windows I just cut out the materials at hand.

Let’s get started …

Oh, I almost forgot about the electricity. Cartridge light bulb connected to the wire, I put into the design of the forms before the pour plaster.

The windows of colored glass fusing master ordered in advance.
Cut holes for the windows a little less than the size of the glass thoroughly, then customized more precisely the size is not right through to insert a glass and it does not fail.

Separately collected wood. From bead wire shaped leaves and nail polish to fill them, making inseparable movement lacquer film. Leves should not be large. About polusantimetra. Otherwise the film is not reliable. Apples and Grushki bought ready-made, strung on wire and adds between leaves. So while I tripled the shape of the crown.

Having collected all the branches to the wire, put them in the house, spreading branches of the back end of the wire on the house.

At this point, gather into a single structure all the parts planned.
To use the bottom of the cover from the pail with water-based paint with a diameter of about 22 cm, cut a hole in it in the form of internal house capacity. Later in this hole can meyat bulb. Fasten the plaster mold above the hole. I primed it. This is a must do between the material layers to improve their connection.
By wire from potrona crepe wire with plug and switch. Carefully isolated contacts.
Planted tree, fence, plaster blank and connecting the layer of putty (it is elastic plaster, but longer drying). Form a house according to the idea.

The windows are sealed with masking tape.

Connection wires ostalos in putty layer. The rear part was formed in the shape of the hill. The raw layer is inserted rods of the fence on the remaining doors form. Serpyanku added. To form the trunk of a tree.
The layer must dry thoroughly. Then a layer of primer and again.

Layer by layer, until I started to like it.

The door and the fence went manganese solution to become more aged wood, and “weed” shaped liquid filler. There was only a painting with acrylic paints, varnish and acrylic lacquer decoration adhesive pretty gadgets to taste.

A little imagination and you’re done.

f I missed, please. It is trying to describe everything.

Creative whole mood!

courtesy: livemaster