For work, we need a basic fabric, padding polyester, the fabric for the lining, different materials for decoration.
To cover carve out a rectangle whose size will depend on your tablet. I hope so the width of the rectangle: width tablet + tablet + two thicknesses of 1 cm to 1 cm allowance for the thickness of batting. Height = height of rectangle plate + allowances. After the main part is cut, stitching it together with synthetic padding.
And sew the cover on the side seams. Try on the resulting “pouch” on the tablet, we see that all the measurements done right.
Now take the lining. Take the same height as in the previous parts, but the width is calculated as the sum of allowances (I 1 cm) and the width of the inner parts, which were obtained in the previous step. (The fact that the width of the pad is slightly smaller than the width of the rectangle of the base fabric layer by batting). Lining is cut out, on the lateral sew seams, while carefully leaving nezashitym opening to cover and then unscrew can be on the front side. Try on the tablet.
It’s time to think about how the same case will be closed, you can use a magnetic button, button, or, as in my case-sticker. I carve and sewed small valve, which will close and cover.
Put the wrong part of the cover in the main rectangle of fabric (make sure that the items were placed facial parts to each other), between investing valve sews.
Evert the resulting cover on the front side (through the hole in the lining of the left), paving the decorative stitch along the top seam, and be sure to sew up the hole in the lining.
