How to make origami “Lilac Swan”
 origami "Lilac Swan"
1. The module collects in the chain, as shown in the photo.
 origami "Lilac Swan"
2.Zamykaem chain in a circle. The result was a circle of 2 rows of modules. In each row of modules 39
 origami "Lilac Swan"
3.Continue to increase the ranks of: 3rd, 4th
 origami "Lilac Swan"
4.Perevorachivaem and continue to build the ranks until they (the series) will be 11.
 origami "Lilac Swan"
5.Vylozhili 11 rows – the trunk is ready.
 origami "Lilac Swan"
6.Perehodim to the weaving of the breast. To do this, put on blue 1 unit, then 8 purple and 1 blue again.
Pletёm only this area. Each series will begin and end with a blue module, and between them in each subsequent row will be one unit less than lilac.
 origami "Lilac Swan"  origami "Lilac Swan"  origami "Lilac Swan"  origami "Lilac Swan"  origami "Lilac Swan"
Vsego breast in 8 rows. 8th row ends with 3 blue modules.
 origami "Lilac Swan"
Teper going to do a swan’s neck. To do this, we will alternate the rows: 2 lilac; 3 blue module
 origami "Lilac Swan"  origami "Lilac Swan"
Sheya consists of 18 rows. So: the neck is ready.
 origami "Lilac Swan"
Budem make his head units turn over and put on the other side. 1st row of the head in the center of lilac 2
 origami "Lilac Swan"
Po sides blue: 1 on each side. Blue modules are put only one pocket; 2nd row head: 3 lilac; 4th row: 1 blue, 2 purple and 1 blue again; 4th row: 1siny, 1 purple, 1 blue; 5th row: 2 blue, 2nd: 1 black, 7th-1 red. The head is ready.
 origami "Lilac Swan"
Nachinaem do tail. The first row of the tail begin to spread from the breast. Modules turn over the other side and spread round: 1 blue, purple 27, and again one blue. Each next row will start and end with 1 blue module. Lilac modules in each subsequent row will be 1 less.
 origami "Lilac Swan"
Vot so it will look from the front.
 origami "Lilac Swan"
Prodolzhaem to increase the ranks of climbing up. The tail tapers.
 origami "Lilac Swan"
Zakanchivaetsya blue tail unit. Here’s a swan we turned.
 origami "Lilac Swan"
Teper will make a stand. The stand we will do the same as beginning to make the torso.
The stand 3 rows of modules, closed the circle. In each row of 45 modules: 2 rows of lavender and one outer row of blue. I lilac modules is not enough, so I replaced them on white. They are inside and they will not be visible.
 origami "Lilac Swan"
Kleevym glue gun swan to delivery. Glue the eyes. You can make a decoration. I have the flowers in the technique of “Quilling” Our Swan is ready.
 origami "Lilac Swan"
courtesy: stranamasterov