How to sew bright felt organizer bag
In order to make such a holder, we need 1-1.2 mm thick felt of three different colors.
Pattern of today’s lesson is free, but only for personal, noncommercial use. In addition, heart asking when copying a master class on other sites do not forget to specify a direct link.
All items, except for the main large, we need in the quantity of 1 pc. Details of the base Holder – 2 pcs. To cut to get comfortable and economical, I prepared a version of the details on the layout of the circuit felt all the necessary nuances.
Pattern printed at the right scale, with the cutting of all do not forget to move the dotted markup washable marker or chalk Holder for future details.
I cut out all the details, finished zippers and metal accessories – any lock, which you like the lightning of 15-20 cm, carbine, semicircle.
Begin collecting holder on the left section of the pockets. We need the following details and lightning:
Lightning gently combine with pocket and tack:
Stitched by and remove Basting thread.
Surplus cut off lightning and singeing section lighter, not to showered. As. unlined pocket and zip remains inside, if desired, you can hem a hidden seam of its outer perimeter, so it will look much neater.
Putting on pockets now need these details:
Stitched by a decorative seam sections as shown in the photo above.
Pocket sewn pink to gray:
Then impose on the connected parts bent in half zippered pocket and tack them in such a U-shaped seam to the main part of the pink felt:
Stitched by, clean gumption. Left Bloc pockets ready!
Getting to the next assembly, the central section. Take two more items:
We make cuts decorative stitches and combine items together, paving the line with label:
Tack pockets for pink based around the perimeter:
Stitched by, remove the temporary thread. The central section assembled!
Getting to the design of the right Holder. We need only two parts:
For details, which in the future will be a loop for a pen, make out the edges of lines:
Then, fold it in half and tack to the pink parts:
Install the upper part of the magnetic key, if you are just like me, chose it as a castle.
Tack block parts to pink basis:
Stitched by, clean nous:
The interior of the Holder is fully assembled, so this has turned out:
Let’s add a few more nice detail. From the remnants of felt cut out a small strip of felt and are preparing a carbine.
Fold the strip, as shown in the photo and baste:
Perform any strong seam with decorative stitching:
We put a carbine and fix the strip on the holder slightly cutting the seam allowance on the pink felt at the site of attachment:
From pruning pink felt prepare very small, striped, or pull out polukolechko ring – it does not matter and is an element of decorative finishes.
We put a ring on the strip and tack on the basis of:
The finale is near, memorable to put the bottom side of the magnetic button on the gray base:
Now connect the gray body panel with a pink, carefully aligning them, and sour cream on the perimeter:
