How to make beads organizer cabin

So, as I did the cells for beads. This is actually my constructor. Each cell can be removed, interchanged, or simply for convenience. The design should depend on the availability of your beads or beads. If beads small in volume, but a lot of colors, let the cells will be much smaller in size, and vice versa. The cells can be square, and rectangular, and high, and flat. Again, I repeat – it all depends on your preferences.

It is very simple and everyone can do.

First, you need to make a “cell”. I show on a sheet of plain paper, but must be made of cardboard for strength. I am a regular school board A4. Rascherchivaem workpiece. My height 3 cm, the width of the square 4×4 cm.

On the dotted line will fold – to its accuracy spend handle with sufficient pressure.

The shaded side will be glued to the first wall.
“Curly,” I cut off the edge at all to the shaded region was slightly less than the length of the other side (this is to avoid confusion when the strips are cut)

Another important point: the whole structure must be perfectly level (perfect of course nothing happens, even for me, but at least we must try).
Glue “cell” should be short edge out, resting in the crook of the first steno chks strips. So we rid ourselves of bias “cell” in the gluing. As it turns out pretty flat square.
Well, actually we do so many pieces as wish our soul and idea.

The cells themselves also rascherchivaem on cardboard. Hatching is clipped on the dotted line handle hold – will fold.
Special feature: the bottom and the height of the wall – a millimeter less than the “honeycomb” (It is clear why: there came to the cell without any problems, but sit tight)
cut and bend the cell. If the beads will be many in a single cell, and will often need to pull it, you can make secure and circumvent each narrow strip of adhesive tape. But I did not bother me and so convenient.

Further, the corner to corner, glue “cell” on the table, that there was no lumens and bottom structure with cells was smooth.Then enter the cell well and gently turn

Already having a total size of “hundreds” do the basic box, where all this beauty will be located. Considering also that the size of the foundations should be more than a couple of millimeters (and height as well) to “cell” quietly entered, but not dangling.

Here’s how it looks to me.
One note: My base is made of the same soft cardboard, or more precisely from the fact of what he was wearing (from the cover).
I advise you to use something more tightly.

If many beads – it is possible to make some of these structures (not necessarily square) and turn it into a chic dresser.

We put the cells in the cell, we pour beads and admire
In order to save I placed six cells on one sheet of A4 cardboard, so multiple cells left with one short little edge. But do not worry – the height of “honeycomb” is compensated. And beads in them to the brim.