Hi everybody!!! So I decided to do a master – class to their bonsaychikam, do not judge strictly because this is my first microns. I called my tree “Paradise”)))
To create a tree trunk I took a different wire .Stalnaya most durable, it goes as a base.
Each wire wrapped with masking tape.
Now you have to connect all the wires in one barrel, tightly wrap the tape molar.
That’s the foundation of our future has turned out trees
Next, it is necessary to plant a tree in the plaster and make a stand. To stand I use plaster!
Dishes I cut out a liter buckets of kebabs. It is still useful to us, so dense bed into polyethylene.
Plant trees in the plaster, dig next to a spoon until the mixture is soft pool for the future of the lake.
After a short time when the plaster dries a little stand, take out from it and do posudku knife grooves to simulate bark.
This is what eventually happened.
Now we begin to create the crown of future trees. From the foam, I cut out the shape of an oval (I think you can also do that from the foam, foam, etc.)
Side view.
The basis for the crown of hot glue glued to twigs.
Now we must prepare the plaster mixture for our tree. For this we need plaster, PVA glue and citric acid. Cover the barrel with a mixture should be in 2 stages. To do this, take 3 spoon with a hill of gypsum,
a bit of citric acid (. is the most important ingredient in this mix, as citric acid inhibits the hardening plaster Before that so tormented with their first trees, the mixture quickly solidified crust and it was impossible to make a more realistic, until I learned this secret;))
3 tablespoons white glue.
Gently mix all
and add half a spoon of water, the mixture should turn out as sour cream.
So begins Phase 1 covering a trunk gypsum mixture.
Bottom line. After drying, begin Stage 2 coating.
So we will look after the barrel 2 stage.
Picture close, here is your imagination with a brush do brozdki, form the crust of the substrate layer 2 mixture.
Then start painting our trunk. Since I am new in plaster trunks and just learning, I will work with cheaper paints and lacquer coating. Masters used acrylic paint and varnish, and I do Colera and colorless quick-drying varnish. I took 2 colors, coffee and light brown. First dyed light brown and the top of the coffee color.
Now that color turned
Then, to create a more natural crust, with a damp sponge should pass neatly on twigs and trunk to get the contrast
We do the same thing with the stand bark
paint as the lake and the land
Further varnish bark and podstavochku completely (it dries very quickly).
This is all the wealth to build our tree crown. Roses I twisted out of satin ribbons 2.5 cm wide, 5 colors. Funtikov organza.
The result of our crown, front view.
Back view.
Well, our tree looks like. Now there stands decor.
Generally photographed on a step by step process I’m too lazy))). There are already on your imagination. Just try to describe.
Back view
I stand covered with varnish again until it is dry immediately placed on top of the pebbles, plastic flowers and grass sprinkled with pink beads. For bonding again prokapat lacquer with a brush.
details
Waterfall I made of pebbles and small shells. In a gorochki gathered them into a pile between a fixed glue “Titan”.
Along the edges of the lake and titanium paste stones and herbs. Inside the lake spread ground dyeing blue gouache salt “Extra” blue stones from their aquarium and blue beads. Then it all flooded glue “titan”.
Over Cockleshells also fill titanium to simulate a waterfall.
Here is such an example !!!
Well that’s all for this !!! Thanks to everyone who came to the end. Photos were very much like to show all the details.
courtesy: stranamasterov
