How to make flowers from beads and sparkles

Sharing is caring!

Here you can use these flowers as a separate bouquet or add to the final composition for decoration.

23

1
We will need:
copper wire with a diameter of 1 mm, length 38 – 40 cm
rod for winding a diameter of 3 – 5 mm,
wire cutters and pliers,
sequins different;
beads in tone to sequins,
beads for the “legs” of the flower.
2
Measure out 38 – 40 cm wire.
3
Fold the tip of the wire with pliers …
4
… And clamped to the first bead could not take place.
5
Is wound on the rod with a small distance between the coils.
6
Length should get about 6 cm.
7
8
Take the opposite end of the wire. For ease of stringing I sawed his nail file that was sharp little end.
9
Begin stringing beads and sequins, alternating between them:
10
11
12
13
Fully close our spring-loaded beads and sequins as shown in the photo.
14
Then do “leg” of a different color beads.
15
Flower 6 cm, “leg” – 20 cm.
16
Fix the loose end of the wire with pliers. Make a loop.
17
To twist the wire around the resulting loops. Clippers nibble too much.
18
We got here a flower.
19
And then we are going to experiment with all the sequins that we have lying around in the closet and start to combine different colors.
20
You can put in the bowl lots and lots of twigs, flowers of the same color.
21
And you can bring together all the different colored. Or add to decorate the bouquets.
23
22
courtesy: liveinternet

Sharing is caring!