We need: 1. The tape fabric. My ribbon is cut from the soldering iron veil, but can take any tape. Dimensions I – 2cm wide and 20cm. in length, and yours may be different.
3. Needle and thread. For clarity, I took a black thread, though usually use monofilament.
4.Pin with a ring or as it is called, the pin.
5. Cap for beads.
We take our ribbon is folded corner and fix the thread.
We put together two side strips (A and B) of this corner, starting forward baste simple suture needle.
And another angle. I apologize for the quality, was in a hurry)))
Sewn to the end and the result is a “sausage”. Threads are not fixed.
Pull the string and prisborivaem. ribbon length should be reduced approximately by half. Fix the thread.
In the little corner that we do not ask, anchoring thread and attached to it a ring pin.
Harboring ring area and tightly sew it.
Screw tape on the pin and sew, sew, sew, making sure to shovchik and thread has always been at the bottom of the fabric and lay down gently.
So doshivaem to the end, remaining little corner bends and fix the thread.
That such should get a rosette. The diameter of 1cm.
The last step – on rosette dress cap for beads (it will cover all the seams