it is very simple to execute work in macrame technique. Outside, the rain poured down, so I decided to pass the time today. The height of the vase – 28cm.
Vase from different angles …
To work required …
I took as a basis the vase empty packaging of tennis balls. For the stability of the glass used in the base cover. It was ideal in size. In the course went glue “Titan”.
Cotton swabs nanoshu lacquer base, gently wrap the twine.
Received…
To make the top and bottom weave two pieces of twine.
I take two strands at 2m 80cm. Reinforcement
Double flat knot.
Further, when weaving a double flat knot pull the loops of yarn in the middle, alternating them.
I continue …
I receive. Such elements 2, their length depends on the diameter of the vase.
Scourge sheet.
I’ll show an example of a large sheet.
It will take a short thread – 20 cm (in the middle) and 6 long filaments 2 80 m B.
Clips (on the top of a long thread), the bobbin thread is short (middle leaf).
Next 5 long strands anchoring double knots on flat short.
I get:
Using the upper thread as a base plate on which Breeden from horizontal rep nodes.
The free ends are fixed on the middle sheet double flat knot.
I continue to weave Brides on both sides, each time the upper thread is the basic.
Double flat knot.
I continue …
The fifth brigade not used closer to the center filaments.
Short strands, which is the middle of the sheet, cut off. On the remaining two strands in the middle (center continuation sheet) pletёm double flat knot.
With each new Rada diminish the number of threads on the same principle.
I get a leaflet. On the two central strands looped weave knots.
Removes excess threads, I get leaflet.
Leaflets I – 4 pieces, they are of different sizes, but the principle is the heh..
Scourge flower.
I picked up the thread of 2 m 80 cm, fix a bundle, the left-hand thread is still 30 cm to the right by the remaining thread.
Scourge units pulling a loop of a long thread, as in the photo
I continue …
The length depends on the need, I spun at the rate of two revolutions.
Holds together, I get a flower. The finished product is added in the middle of a bead. On my vase of flowers – 3 pieces.
In all the work it took less than one hank jute twine (100 m).
Stems with a flourish – a wire wrapped with twine. All finished elements are fixed by means of an adhesive “Titan” on the vase.
I get the finished product.
courtesy: liveinternet
