Hello dear people of Masters Country! I want to offer you a framework for the production of MC, baguettes from newspapers. I hope that this will be useful to you, as I do. At one time, as a student, this production of frames, helped me very much in material terms, as the wooden frames were pricey and educational work was necessary to draw salary in :). The idea of this baguette taken from the magazine, “iZhizn Science”, I am so old that reading this issue of the magazine live))), and it struck me in the article is not about the manufacture of frames, and the cover sheet, on which was depicted a baguette with a photo of Block, a baguette was very rich in volume. I would like to share with you a way to manufacture the frame.
We begin to twist the tube. Or wire spokes, I recommend that, in this case, to lay down straight, parallel to the edge of the sheet, and later explain why. Purple Wave is the glue spot.
Folding presses and twists.
That turned the edge of such a tube.
And that’s what it was necessary to put the needle parallel to the edge lista- just that used tube was the same size on both its ends. Just if frame was used Tailor, say, 3-4 tubes on the edge, as if something was not critical way of winding tubes, but when they were 8 and bolee it will be quite difficult at the same pieces and edges can be of different widths.
… And so I chose a photo, clocked a certain number of tubes .
Before making the manipulation of photos, I have it, “laminate” film for pasting textbooks, because future frame will legkovat glass can not withstand the load, and photos all are still needed to protect.
Merge the first row. For this I chose a double sided tape, although the adhesive and paper strip instead skotcha- no exception.
I decided for myself that in the first row I would have 8 tubes. At this stage it is possible to construct frames.
here’s how …. but I’ll want baguette, but not framed
coat with glue between the tubes, I PVA.
I superimposed and pressed lightly the second row of tubes …
… Is similar to doing a third and fourth row. This is already visible volume of the preform.
For extra volume side I pasted 6 more tubes, most importantly, in the other three blanks repeat a railway alignment tubes.
Taki vot workpiece future prints. Immediately determine for themselves that the high edge of the outside I will.
I measure the width and height of the picture and subtracting centimeter on each side. This is to ensure that it were possible to insert a photo into the frame.
14/19, see -To be the size of the inner edge of baguette.
blank on the back side, virtually identical.
… With a protractor and compass angle of 45 degrees can make everyone … but with the help of a rectangle and two identical pieces, but students do not have time to pass session
cut off a corner straight sharp knife stationery … can anyone have the bit for cutting such uglov- I’m so, unfortunately, has not yet got hold of.
..skleivaem blank rectangle there will be no harm ….
liberally smeared with glue edge, I glue-titanium.
to dry fix masking tape
although this is not necessary, but I still train the same make internal rim for a photo of the three tubes … just not sticking together, I took three rolls and cut off pestering photo corners at 45 degrees
..tak’s reverse side bageta- removed protective film double-sided tape, rope and taped dopTrubochki
Well, that’s done, did not paint – because it has not yet decided where to hang the prints
sideways, for volume …
I hope you are not tired … I hope my work was not useless … This baguette is possible to paint, decorate and zadekupazhirovat already on your taste, but I like to just be a simplified version.
courtesy: liveinternet.ru
