Flowers themselves are very beautiful. But to enjoy the beauty of fresh flowers, you need to work hard. Not everyone is capable of such work. If you’re the kind of person – you will approach the artificial flowers. They can be made by, for example, of paper.
For gerbera pink paper, you will need several shades, green for the stem and leaves, black and yellow for the core, toothpick, glue, scissors, a little clay. 1. To begin with glue between the strips of pale pink rozovyei bright. Length 30cm and 15cm respectively. These strips need 16.
2. Of these, screw the helix and dissolve them to a diameter of 14mm.
3. Pull down the spiral on both sides giving them the shape of the eye.
4. The need to glue the petals of a crow. It is a circle with a diameter of 16 mm cut radially overlapped and glued.
5. Start glued onto the inside of the funnel. Stick, leaving space in the center for the midway. On the back side of the funnel glue the petals so that they were already glued between the petals.
6. To stem convenient to use a piece of thick wire – it can bend for better flower arrangement. But if you do not use a toothpick wire.
At the tip (for clarity, he was left without paper) Screw tight roll of green colour. The width of the roll depends on the remaining space on the funnel. Squeeze a little roll in grease glue and glue the flower.
7. The core will roll out the black, yellow and pink stripes. In the last two should be cut fringe.
Glue them together. Screw on a toothpick since black.
Glue in the middle of the funnel and fan.
8. While the flower dries, make a pot. For him, you will need a tight spiral diameter of 2 cm. The width of the strips 7 mm.
Squeeze your fingers vase. Make the bottom flat. Inside the walls, smear glue. After drying, the vase will be tough.
Inside put clay, well push it to the bottom and walls, so it does not hang out.
It insert the stem. Zamosc paper. Glue the pieces of the base.
Now the flower is ready, put it on the site of the reviewed so that everyone can evaluate your work.