Make a house a beautiful and original watch from scrap materials is not much difficulty and time-consuming.
Self-made watch
For the production of crafts is required:
1 – the mechanism of the clock. It is best for this purpose suitable mechanism from a small and inexpensive budilnichka;
2 – CD ROM; It is advisable to choose a new one with good refraction of light rays;
3 – oval, round or square plastic small plate;
4 – 3 mm wire diameter of about 30 cm;
5 – rhinestones 12 pieces;
6 – small strips of metal from beer cans to the manufacture of arrows;
7 – golden sequins;
8 – acrylic or other varnish.

Step 1: make the CD layout, dividing it into 12 segments, glue rhinestones to put on them numbers. In the center of the disk cuts through the square hole the size of a clockwork. The central part of the front of the drive to seal the painting, leaving a hole for installation of the arrows. We put in the drive mechanism on the small arrows pasted strips of metal. The basic unit – the dial mechanism and arrows ready.

Self-made watch
Step 2: a cut through the plastic plate is the same square hole as in the disk CD. Here it is necessary to observe accuracy after installation mechanism in the slot, he was sitting firmly.
Self-made watch
Step 3: Wire make a stand on which to stand hours.
Self-made watch
Step 4: lightly spray from the spray front of the plate, sprinkle with glitter and allow to dry. Top again can be covered with varnish.Again, let it dry.

Step 5: fasten the stand plate and metal straps from fine wire in 3-4 places.

Self-made watch
Step 6: Insert a mechanism with a dial on the plate, on the back side of the clock and the plate can be fixed with adhesive. Hours are ready
 
Self-made watch
Self-made watch
  
Self-made watch
Self-made watch
courtesy: rukodelie.usamodelkina
Shares