Stunningly-spring casket out of nothing! Kick-ass idea! You can keep it small ornaments or candy
You must have the following:
- spools of wide adhesive tape
- double sided tape (thin)
- artificial grass
- green paper
- thin strip of soft plastic (for pen)
- manicure tool or a pen
- strips of palm leaves for decoration
Encircles the bobbin on a sheet of green paper and cut out the circle. Encircles the bobbin on the cardboard and cut out the “sun.”
Manicure tools or perform a pen on a contour. Now it is easy to bend each “ray”.
Strips of double-sided tape to stick with one end inside the reel and the opposite edge of the outside. Slice the green sheet of paper into strips 1cm. Alternately, remove the protective paper from the adhesive tape and glue strips of paper overlap . Inside the reel butt glue to the edge of the bobbin. Next, fold the strip and glue to the outside.
Stick on the bottom of the bobbin double sided tape, “sun” out of cardboard with a green circle to try to reel. Further alternatively remove the protective paper from the adhesive tape and glue the bottom.
Glue a strip width of 1.5 cm at the top of the bobbin. On the bottom of the double sided tape to stick.
Cardboard strips 1.5 cm wide wrap the basket and hook in size. Overturn the basket and draw out on cardboard, make “sun.” Next, sticking it on the double sided tape to the strip.
For baskets with grass
Papered lid with tape and then grass. On each side of the strip on the adhesive tape pasted palm leaves.
For baskets with handle
Glue on top of a circle of green paper. To get the handle strip of soft plastic or cardboard. On one side of the stick adhesive tape and carefully wrap the strips of palm leaves. Glue the handle to the lid. Boca okleit scotch stripes on palm leaves. Melt the ends secure.
Now options décor baskets.
1) Remove the protective paper from the adhesive tape and glue artificial grass. Take a strip of palm leaf and grass arbitrarily wrap, fasten it. Melt the ends fastened or tying a bow.
2) Remove the protective paper from the adhesive tape and wrap reel strips palm leaves. Melt the ends of anchoring.
Now the fun part – decor!
For flowers, I use office paper. From one sheet 14 obtained florets.
Mode sheet lengthwise into strips 3 cm wide.
Each strip divide into 2 parts.
One flower needs strips about 3 cm x15 and midway 0.3-0.5 x15sm.
Fold in half along the wide strip to be folded easily,
I spend a strip manicure tools.
Are bent corner and thus cut it.
From this angle, cut into fringe.
At first, it seems difficult to cut and not cut at all, but after 10-15 flower hand gets used.
Glue a thin strip under the broad.
! Option without midway – just start spinning immediately strip with fringe !
And now with the help of quilling tool-cheat pinstripe.
The tip of the tape is better to bend, so it will be easier to wind flower.
Screw better with tension, the picture roll weakened without hands.
When you start cranking the flower itself, the paper will wave, but try to keep this wave, Do not bend the paper. Then the flower opens and is lush.
At the tip of the drip glue and hold until the flower is not secured.
Flower size depends on the width of the strip, just experimenting.
Bottom view. I glue in the middle of a drip to flower not try to unwind.
Melt Glue flowers . Done