We will be learning to make such flowers.
So we need to work: 1. thin wire (I 0.28); 2. thicker wire (I 0.74); 3. sewing threads of different colors; 4. spoke; 5. beads; 6. florlenta. To start cut off equal to the desired length of thick wire. 5 pieces for the petals and one for the authenticity of the leaf
Let’s give them a form of petals and leaves, shape depends on your imagination 🙂
Now take a needle and begin to wrap her thin wire
Winding as much as possible, I wrapped almost the entire needle, it will be easier to unwind than to start again 🙂
Remove from spiral spokes
Now start evenly and progressively stretched spiral
After some of the stretch, this dress on the spiral shape of the petals harvested
When will put on a spiral shape desired length, leaving the other side a few extra turns of the spiral for further twisting spiral and all forms
Twist the ends of the workpiece and spirals
It turns out we have 5 petals and one leaf. Stalk you take the necessary wire length (again, it all depends on your imagination), fold in half and twist the ends
Take three beads and do stamens, we collect bead and twist the wire, do these three stamens. The length depends on the size of your flower 🙂
Attach to the stem stamen
Now proceed to the winding spiral. Winding in parallel, each turn of the spiral, watching the thread tension
Winding in parallel, each turn of the spiral, watching the thread tension
Winding in parallel, each turn of the spiral, watching the thread tension
Now reaching the end of a leaf summing up the thread on the back side of the sheet and coil wire promatyvaya through about the middle of the sheet skip the thread through the front side of the sheet to the bottom
Skip the thread through the front side of the sheet to the bottom
Please be advised before the end of the thread and fasten it. To do so with all the petals and leaves
Our billet ready. Have a stem, 5 petals and one leaf
Begin to build a flower. We fix three petals on the stem. Cut off 30-35 cm thin wire and wrap attached petals
Attach the two lobes and winding wire
Winding stem floral tape (or floss, do not forget to fasten with white glue). Attach the leaf and wrapped with a tape the whole stem until the end 🙂
Our flower ready
And they look next to the colors of beads
