1

2

3

Feed 5 cm to 10 cm. Cut the right amount of soldering. I took on this rose petal 21.

4

Folded over the edges and sewn strings to themselves petals were not strongly refluxed and were more natural sewn as pictured.

5

6

Ball of Christmas toys or sheathe paste satin ribbon yellow. it is our middle,. who do not have the ball, you can use all the available small-diameter ball shape.

7

Glue the petals in a circle overlapping the first petal.

8

9

The ball is completely plastered with petals look like they are located! again for a greater resemblance to glue overlapping petals.

10

Here’s a void formed after sticking petals. Do not worry there is salvation in almost every home.

11

cut out the circle and glue

12

Arrows or sharp petals. Honestly, I was looking for this IC is very, very long time. Saved me again contact, the group was shown how to do it completely. I also decided to show someone else can not see, let it be I have.)
The tape 2.5 cm to 12 cm folded in half.

13

Iron ruler presses our leaf and hold the soldering iron.

14

15

Both parts come in handy, I read that many throw mate, but I felt sorry. And I also find it of use.

16

17

First glue our “not beautiful” leaves.

18

It should look like this, well, or prettier than me.

19

in the middle of a drip glue and flatten it to get a flat.

20

Glue between the first row of arrows, and we received a very nice bottom. and waste, we also do not

21

Another leaf who do not know how to do the show. tape 5 cm by 10 cm

22

shape as in the picture. tried to draw a pen Lambent but even more, had cosmetic white pencil to make it clear as I have them cut out. in fact it is very easy.

23

24

do with the back of the knife heating it over the fire literally seconds from the beginning of 5. I spend a hot knife on the towel and then only on the sheet to make sure that it is not very hot and not melt us leaf.

25

That’s all. Glue the leaves on the stem wire and wrapped with satin ribbon, in my case it is 2.5 cm.

26

27

28

29

Shares