I suggest you make yourself a little baby-pocket bag, decorated braid of piping.
For work, we need:
materials:
Scraps of two types of fabric (I used scraps from cutting sundress, the approximate rate on the lining 30 * 21 cm, on the back of the bag 15 * 21 and rags for making an oblique Bakey).
Decorative buttons.
Rep ribbon to the handle (depending on the desired length of the handle, I have 90 cm).
Dublin cloth (a piece of 30 * 21 cm).
Threads in tissue tone.
for the paper pattern.
Instruments:
Scissors.
Needle.
Pencil or marker to mark on the fabric.
Pins.
Equipment:
Iron and ironing board.
Sewing machine.
Getting Started.
Let us make the pattern of the paper, its circuit in Fig. The pattern is built on half of the folded sheet, after cutting unfolds.
2. we will cut out the two kinds of 3 cm wide strip of fabric and a total length of 2 m from each type of tissue. Since I’m cutting out of the scraps, then just cut small strips.
3. blotted iron edge strips on the reverse surface, so that the turned tape/ribbon width of 1.6 cm. The preferred to use a specific mechanism for this process. The width of the inlay may be different, in which case changes its flow.
4. Cut the finished inlay on the pieces.
5. pin holes inlay fabric of one type on the ironing board, as shown in Fig.
6. Now plaiting threaded lengths of cloth inlay of other tissue between the pinned staggered and also fix them with pins on the ironing board.
7. trimming weaving to eliminate gaps should get a smooth mat.
8. Impose on him a piece Dublin 22 * 15 cm and glue.
9. From the obtained web to cut out part of the pattern bag with an allowance of 0.5 cm for all slices, trying to observe the direction of weaving. I cut out a similar piece of fabric for the back of the bag and its sizing Dublin.
10. Fold details right sides inside and grind the perimeter at a distance of 0.5 cm from the edges, leaving an open top cut bags.
11. 2 cut out parts of the pattern with an allowance of 0.4 cm from the backing fabric grind as main parts bags, but leave an opening in the bottom 5 cm.
12. The edges of the tape shall be a rep on the fire to keep it dissolved. The main item bags put the tape-pen and be pinned to the underside of her handbag, it follows that the handle is not twisted.
13. Adds body panel bags and lining upper open cuts to each other by sharing the side seams.
14. grind for entry into the bag perimeter at a distance of 0.5 cm from the edge.
15. everted bag through the aperture in the bottom pad.
16. The lining is sewn up by hand. Put the lining in the main part, spawn entry edge into her purse and steam.
17. residue oblique inlay 13 cm, folded into halves along a face outwardly and press out close to the edge, is obtained for the ribbon loops. Ribbon superimpose on the reverse side of the bag as shown in the figure and sew at a distance of 0.3 cm from the ends of the tape.
18. Collar turn away the top and sew again.
19. Sew on a button on a small cotton stalk. Locate a button is necessary that to buckle loop is not contracted handbag, but not loose.
20. fastens on eyes. Our little “wicker” bag ready.
Notes: size and shape of a handbag, of course, can be changed. For decoration you can use ready-made oblique Bakey different widths, it is important to calculate the flow correctly.
Good luck in the performance of creative ideas!
courtesy: livemaster
