– zipper (~ 35 cm), preferably with iron teeth that did not merge with the color of lightning
– thread in tone
Rose with petals she does so
1. unbutton the zipper almost to the end, we fix the first petal as in the photo. 2. Make the second tab. 3. And next to used up half of lightning. 4. Just do a few petals of the other half of the zipper. 5. Allow a few inches of lightning do we fix it and the middle of the spiral roses. 6. Sew on the pin. 7. Done! We are looking for somewhere to attach
Spiral rosette for its creation should be used disconnects lightning. brooch is done as follows: 1. disconnects lightning, we need only one half. At the request of the slider can be removed if you do not want to be present on the brooch. 2. Spiral fasten the zipper to the end. 3. Sew on the pin. 4. Brooch is ready! The third brooch –
How it’s done: 1. Fix the petals as in the photo; between them should leave a gap for the petals of the second floor
2. So until exhaustion of the first half of lightning. 3. Making the petals from the other half, putting them between made. Optionally, you can sew the thread on the back of each petal with each other. 4. Sew on the middle of the flower. 5. Fix the pin. 6. Brooch is ready 🙂 The fourth pin requires imagination. To create it, we need: – zipper (~ 20cm) – all kinds of beads, rhinestones, ribbons, beads, etc. – to pin brooches – thread – needle – scissors makes it so: 1. From the first half of the two lobes are doing. 2. Do the same on the right. 3. Decorate as we want and what we want) 4. Fix the pin. 5. Done!